Instruments and method, not estimates
Calibrated anemometers, flow hoods, ultrasonic flow meters and manometers are used throughout, with readings recorded per terminal and per circuit.
A system installed is not a system working. ECS carries out testing, adjusting and balancing with calibrated instruments so every diffuser, AHU and chilled-water circuit delivers its design flow — and the report proves it.
Calibrated anemometers, flow hoods, ultrasonic flow meters and manometers are used throughout, with readings recorded per terminal and per circuit.
Operation theatres, pharma clean rooms and labs get pressurisation cascades, air-change rates and filter integrity checked against the applicable classification.
The deliverable is a complete TAB dossier — readings, deviations, corrective actions and final values — accepted by consultants and auditors.
Yes, third-party TAB and commissioning verification is a standalone service we regularly provide.
It depends on terminal count; a typical floor plate takes a few days, and a full building is planned as a phased programme.
Deviations are documented with probable cause and corrective recommendations, then re-tested after rectification.
Free site visit anywhere in Hyderabad. Our engineer measures the requirement and returns an itemised proposal within one business day.
Almas Plaza, 10-3-304/9/401, Humayun Nagar Rd, beside Medivision Eye Care Centre, NMDC Colony, Venkatadri Colony, Masab Tank, Hyderabad, Telangana 500028
#TAB #Commissioning #HVACTesting #ECSPlanet